2002-2005 Honda VFR800/A Wire Harness Replacement Manual
download If the 18P (light blue) connector is in abnormal condition as shown below, contact TechLine at (800) 421-1900, option 9. FRONT SUB-HARNESS REPLACEMENT 1. Remove the front sub-harness from the...
View ArticleHONDA GL-1500 Trailer Wire Harness with Relay INSTALLATION MANUAL
download Seat: (if optional accessory wire is to be used) After removing trunk pan, run a stiff piece of wire from the bottom of the left saddlebag frame behind the rear tire up until it comes out...
View Article1982-2005 Harley Motorcycle Removal and Installation Instructions
download ” bolt from the mounting stem on the Signal® mirror. While seated on the motorcycle, position the Signal® mirror on the handle bar. Secure the Signal® mirror to the handle bar using the 5/ 16...
View ArticleSR-C400 Motorcycle Security System INSTALLATION MANUAL AND USER'S GUIDE
download Routing the Antenna Wire The MCM includes an 18″ antenna wire. The first 12″ is a coaxial wire; the remaining 6″ is the reception antenna wire. When routing, try to avoid running the antenna...
View ArticleHONDA Ground Effects Installation Instructions
download Wiring Installation: 1. Remove the four M8x1.25 socket head cap screws from the seat and remove the passenger handles and seat. 2. Remove both rear side covers, and right front side cover. 3....
View ArticleHarley-Davidson Electronic Ignition Module Installation instructions
download Step 1: Switch main dashboard switch to “off” position (Ignition& light switch) Step 2: Disconnect negative (ground) cable from the Battery Step 3: Remove the Condenser and Breaker points...
View ArticleAudio Oil Pressure Alert Relay Installation Instructions
download Step 1) Wire Connection: Using 18-gauge automotive wire, connect the audio alert relay as shown in the Wiring Diagram – Figure 1. • Connect the supplied wire from #3 terminal on the audio...
View ArticlePulsar Electronic LED Turn Signal Flasher Unit Installation & Operation...
download 1. Locate the stock flasher unit on your motorcycle and remove it. Refer to your motorcycle’s shop manual. 2. Using either the test light or voltmeter, connect or touch one lead to the chassis...
View ArticleBMW R1200GS Dual Function LED Running Lights and Flashing Brake Lights...
download The flasher is set to flash continuously as long as the brake is applied. To convert to a 5 second flash and then stay solid while the brake is applied, cut the green wire loop on the flasher....
View ArticleHARLEY-DAVIDSON Starter Relay Location Guide
download Touring 1998 – 2007 Additional Notes: Relay Location: Under Seat in rubber Boot Battery Connection: Under Seat,Visiable Installation Notes: No Access Issues Factory Relay Type: FULL SIZE...
View Article